Jeremiah23
lvl.1
United States
Offline
|
Hi Folks! (If this is the wrong thread or forum to ask the following question I do apologize!)
I am tweaking some of the finer settings on my DJI Flamewheel f450 build and have a question about Failsafe settings.
(Currently using the Naza-M V2 with GPS. My controller is a rebranded FlySky FS-i6).
What do some of you suggest for failsafe settings on your controller?
Right now I have it set to just turn everything off (which is bad since flipping failsafe will drop the drone like a rock out of the sky). I know I can change my settings so that the drone doesn't move around, but what about throttle? Do I set it to go down to 50%? More? I assume that if I set it at a specific percentage it will allow the drone to maintain altitude so it can do the RTH feature, but I don't know exactly what I should do to make sure it happens.
Am I doing this completely wrong, or is there a specific setting I need to tweak in Naza software to ensure the drone doesn't fall from the sky when I hit failsafe?
|
|