karcio
lvl.3
Flight distance : 313294 ft
Offline
|
Hi,
OK, small update:
Today I notice the same behavior. So, I set timer to 10 minutes on my phone and start charge battery. After about 5 minutes, second led (led2) start blinking, then after some time led 3 and led4. All looks like normal charging
Finally my battery was charged to 100%.
In the morning i had chat with dji and they suggest me to refresh firmware using Dji Assistant 2. So, I put my failed battery (charged 100%) to mavic, connected usb cable to PC, started drone, and stated DJI Assistant 2.
In Firmware Update - section Assistant show me following message:
"Firmware incompatibility detected between some modules and current device. Update firmaware?" I confirm update
After while, update finish success, and I could power on my drone. Did not have a time to fly, but so far all looks OK now.
I will update this thread after few flights on this battery - if all good I will close thread.
Regards
|
|