Hello,

I'm upgrading my S1000.

I installed an A3 Pro Flight controller system, I finished successfully system setup but I can't do the gimbal work.

My S1000 has installed a Zenmuse Z15/5D, after power up it does successfully self-testing sequence but status led remain flashin red.

Somebody know how to solve it.

thanks

Additional info:

I'm using a 2 Futaba receivers, one for S1000 and another one for Gimbal. In Assistant 2, I try to configure Gimbal to SBUS and it go back to LB2. Is not possible to setup it too SBUS. Same for Landing Gear, I change setup and software discard changes.

I opened Gimbal setup App to check it configuration and all is ok, all controls are working fine.

The only thing is the communication with A3.