ACSoft
 lvl.2
Flight distance : 70778 ft
Offline
|
I known that the radio command should better be switched on before to switch on the drone and the contrary for switching off. In other words, acting so that the receiver (the drone) always receive a signal. This is always what I am doing, since my first RC model in 1970 !
Now, without braking this rule, not starting the app before the aircraft is on is impossible (almost on Android), because there is an automatic launch of the app, when you power on the radio command. Now to say, with previous version of DJI GO 4 app and/or drone firmware, I simply NEVER had this problem. So, to my view, it is obviously something bad or broken in actual versions.
EDIT:
Might be possible, if I disconnect the USB cable each time and reconnect it only after both hardware are on. Will try by curiosity, but doing this all the time is not acceptable.
|
|