rfAndy
lvl.4
Flight distance : 396365 ft
United States
Offline
|
So I fire up the M210RTK with latest firmware on all components. Z30 on gimbal I and XT on gimbal II. Both have latest firmware. I start Pilot and it tells me that some of my components are not activated and that I should activate. Huh?? Never seen that before. So, I connect bird with 2 x cams to the PC and ran Assistant 2.0.2 for Matrice and it showed me: 01.01.0900-. The minus sign means some component is not updated. Of course, the firmware for both XT and Z30 is resident on the individual cameras. Both were confirmed to be updated by looking at SD card and update log therein. I ran through update sequence with Assistant and it told me everything completed. Yet, I still see minus sign and Pilot still telling me some components not activated. I then removed Z30. All is good in universerse with just XT. I tried switching gimbal positions - NG. Problem still exists when Z30 attached. I tried a gimbal calibration (DJI's advice). Of course, it made no difference. I also notice a high frequency vibration in the gimbal. You can hear it and feel it if you touch the gimbal. It is not visible by just looking at camera. This is the 2nd Z30 I've had. First was DOA new outta box. This one also has the drift problem that others have reported. Do I need to send the Z30 back as well?? I am not very happy with the quality of the build, that's for sure. Also, many reported problems including drift and frame loss while streaming. What gives?? Any siggestions out there in M200 land??
|
|