Hi. Thank you for raising your concern to us. I will be sending you two DJI video links on how to properly connect the RC to the Spark. Hope these DJI video links can help.
JavierSpark Posted at 2018-6-16 11:00
So, every time that I use the RC, I must reset the aircraft wifi (power on - hold for 9 sec) to use it again with the phone.
Why don't you always use the RC ? It give you far more distance and reliability than using just the Phone.
If you use the Phone ONLY you need to (Power on - Hold for 6 Seconds) to enable Virtual Joysticks again on the Phone.
If you keep switching from the Remote + Phone to the Phone ONLY, you will need to do the Procedure each time.
Here you have explained the Beeps when you hold the Spark Power Button to change the Type of Connection you want -
After the Spark has been powered on, press and hold the power button for:
3 seconds (or until you hear 1 beep) to link the remote controller to the Spark
6 seconds (or until you hear 2 beeps) to disconnect the remote controller (so you can enable virtual joysticks on the Phone)
9 seconds (or until you hear 3 beeps) to reset the Wi-Fi
Thank you very much!
Some times is easy for me not to carry on with the RC, so I want to use it only with the phone.
I have to try again, but I think that I need the 9sec reset to see again the aircraft SSID.