Pedro Gonçalves
lvl.1
Brazil
Offline
|
Hello everyone!
The gimbal of my Zenmuse Z30 camera does not respond to any movement command whatsoever. Has anyone seen this?
When I turn on my M210RTK or Matrice 200 with this camera, it does it's normal movement during startup. However, it will not move in any direction after that.
The camera is working fine. It takes photos, records videos and zooms.
I have tried without success:
- Gimbal controls on the cendence controller,
- Tap, hold and drag on the CrystalSky monitor,
- Tap zoom of the Z30 - It does zoom but doesn't move in the direction of the target.
- Gimbal calibration - doesn't complete and shows message "gimbal calibration failed".
Any help is appreciated.
|
|