Hello,

My mavic took a hard tree hit some months ago. the Drone did take a hard hit.

The camera was damaged which actually takes very little to do. I purchased a whole new camera assembly and installed it.

During install I noticed that one of the ribbon cables on the front had popped off in the crash but this is fine as the new camera required me to unplug this and re install which I did.

Drone is back together and camera seems to physically move well.

When powered up I get no image on my APP and I get warnings that Vision sensor error. I've tried to calibrate the vision sensors using DJI assist but the screen only shows as blank white on my computer and shows none of the things like the box to follow etc shown in the demo.

Any one out there have same issues?


ken

Hi. I am sorry for the trouble. Can you please send some videos for us to check.