djiuser_F6X6cbXW1L7u
lvl.1
Flight distance : 93353 ft
United States
Offline
|
Hi all!
I just got the Ronin-S. However, I can't seem to get the roll axis to properly balance. Whenever I move the roll axis 45 degrees, the camera moves back to a horizontal position. I've read that in other gimbal setups, this can be a result of having a bottom heavy setup. That being said, I'm using the Canon 6D and the EF 50mm f/1.2, which are both supported by the Ronin-S, so I would think it shouldn't be an issue. I can get everything else pre-balanced EXCEPT the roll axis. I have tried balancing with and without the riser plate with no success. The Ronin app says I properly balanced everything. With the motors on, it mostly works OK, but I can definitely notice that rolling the camera isn't the greatest. I haven't done too much testing with the motors on because I'm not sure what kind of damage can happen when the rig is unbalanced. If anyone has any ideas, it would be greatly appreciated because right now, I'm super bummed about the whole thing! I have watched probably 10 different youtube tutorials and none of them have helped. Maybe I have a defective unit?
Here are the motor parameters (not sure if this helps)
Pan 34
Tilt 41
Roll 31
Pan Tilt Roll
Power 0 1 1
Attitude Error 0 0 0
ATTI 0.3 0 0
Thanks,
Allan
|
|