KurtGuy
lvl.1
Australia
Offline
|
Hey DJI,
I've noticed that the Telemetry / OSD on the DJI Goggles RE via the Ocusync Air Unit on my drone is not working while armed. I've attached a link for a video to show a example (http://youtu.be/Wx4mS85zxzE). Everything works fine while disarms but the second you arm the drone the Voltage / Current / Horizon Level all freeze up and dont update until you disarm the drone again. I have tried Firmware V01.00.300 / V01.00.400 / V01.00.500 and Betaflight versons 3.2 / 3.3 / 3.4
Hardware Setup:
Mateksys F405CTR F4 Flight controller (Betaflight 3.4)
DJI Ocusync Air Unit (Current Firmware)
DJI Goggles RE (Current Firmware)
I can see most people have this problem and i was hoping the latest update would fix this issue but seeing i have just updated and tested it now ive found that it still doesnt. Is there any fix anyone knows of or can this be passed onto engineers to be fixed for the next update???
Thanks.
|
|