Hello!
I recentlyhad a crash with my Phantom 2 and had to exchange the gray 4 pin connector goinginto the Gimbal, like here:
I ordered anew connector and exchanged the broken one and now the SD Card Symbol isactivated again in the iPhone App from DJI (this was grayed out with the broken4 pin connector). Also the other symbols in the App are fine, e.g. Battery, etc.However, the GPS Symbol stays gray and the satellites are always zero (but Ican perform a compass calibration and also the Attitude and Speed values in theApp look reasonable). In addition to the gray GPS symbol, the App displaysat the top: GPS is disconnected. I thought maybe the GPS module is damaged andordered a new one and exchanged it, but it did not fix the issue. Also, when Iconnect the Phantom to the PC and start the DJI software, and switch to the tabupgrades, the GPS Hardware and Firmware is 0.0.0.0 (all other parts look fine,e.g. Main Controller, Receiver, Battery, etc.). Has anyone any advice for me,what I can check to fix the problem?
Best wishes, Jan
|