Does anyone know the torque specs for the two quick release propeller mount bolts. (The bolts that attach prop mounts to the motor.) I'm assuming it will be in newton meters.

Hi, thanks for the inquiry, may we have the screenshot of the specific parts that you're asking so that we could check as well if this is advisable and it will not affect the warranty of the Inspire 2. Thank you.

I reinstalled them recently, I didn't use a torque wrench, so unfortunately I don't have the answer you were looking for.

I can say Just tighten them up good. Make sure you have some thread lock on them. I noticed when I was unmounting them that dji only put it on one of the two screws. So one screw came out very easily and the other was very well locked.

Didn't think this was a great idea so I put a little thread lock on both screws when I was re-mounting them.

It's been working perfectly since.