BoddaH1994
lvl.1
Flight distance : 2251 ft
United States
Offline
|
Hello everyone,
I recently had a crash with my Mavic Pro. The result was a damaged gimbal. It was giving me the infamous "gimbal motor overload error" and no video feed.
Since then I replaced the gimbal arm, ribbon cable, and video cable. I now have a video feed, but the gimbal still slams to the left and right and then sits askew without allowing me to have control. My friend who is a tech guru did all this work for me. He suggested replacing the front sensor/camera/gimbal board next, but he asked me to post on here to see if my issue would be condusive to that board going out. Has anyone had any experience with this? Are there any other suggestions?
Thanks in advance!
|
|