adamjrichman
 lvl.2
United States
Offline
|
Yup! I was going to suggest the same. I also am running the Ronin-S with a Teradek. Got the Teradek balanced above the lens on my setup.
Glad you found it though. Another odd note, on the Force Pro you may find 5 USER settings and one Default. Default corresponds to User-1 on the Ronin-S. User1 = Ronin-S User 2, and User3 = Ronin's User 3. If you set the Force Pro to User3, 4 or 5, it will instantly kill the motors because it has no profile to correspond to. Be careful.
I've set user 1 (default on the Force Pro) as good settings for Gimbal-only use, user 2 for the Force Pro when used "handheld" aka attached to a 703 Bolt, and user 3 for tripod use. For tripod use, as you found out, I've set deadband super low, 1 to 3 works well.
These two devices presented an incredibly frustrating experience before sorting all this out. Took like 3 days of prep. Insane that there is 0 literature about this. I may make a video / blog post so everyone else can get up and running faster. |
|