I am having trouble with saving the settings using assistant 2.  how do you do it?   I have N3 and connected to Taranis x9d/x8r via sbus.  I can sett everything up like I want it to be and then I shut down the software, disconnect to the computer, disconnect the battery, and turn off my Taranis.  when I setup to run without propellers to make sure it works properly, I cannot get the motors to startup.  they used to startup but now they don't. not sure what happened there.  so when I go back into assistant 2, I have to set just about everything up again.  the sbus connect doesn't seem to work.  I end up having to calibrate  the sbus setting again, plus all of my switches have to be reset. what am I doing wrong??

I have a remote control Futaba 14 and flight controller А3 .  After the last update in the tab Remote Controller disappear values as Basik channel and Advanced channel. I do the calibration and the next time everything is repeated. What can be done ?