Hello DJI

Me and a friend were flying a Matrice 210 RTK with master and slave controllers. I had control of the gimbal in my master controller and was taking some photos with the Z30 camera when, suddenly, the aircraft status bar on my monitor turned from green to yellow and the message: "gimbal tilt error" appeared. Oddly, the same message did not appear in the monitor of the slave controller. The slave's status bar remained green with the message "In-Flight (GPS)". Any further attempts to take photos with the master controller failed, while the slave could take photos normally.

I am mostly interested in understanding what the "gimbal tilt error" is and what could cause it.

Best regards.

Pedro

Hello DJI

Me and a friend were flying a Matrice 210 RTK with master and slave controllers. I had control of the gimbal in my master controller and was taking some photos with the Z30 camera when, suddenly, the aircraft status bar on my monitor turned from green to yellow and the message: "gimbal tilt error" appeared. Oddly, the same message did not appear in the monitor of the slave controller. The slave's status bar remained green with the message "In-Flight (GPS)". Any further attempts to take photos with the master controller failed, while the slave could take photos normally.

I am mostly interested in understanding what the "gimbal tilt error" is and what could cause it.

Best regards.

Pedro