Hi,

I had this problem before the .500 and rc firmware update and also did appear after the firmware upgrades.  I was flying this morning and noticed that the video feed had the zebra stripes when an obstacle like a white sheet is detected or a white water tank.  when I checked the video cache (since my regular video didn't show up on the sd card - posted a thread on that earlier), it was fine on the phone and no stripes.

This evening after both the firmware and fly database upgrade, powered both air and rc and note 4.  I was indoors with not that much lighting and the stripes started to appear.

Please advise and thank you.

This sounds like an exposure indication. That is pretty common on most video products these days and can easily be turned off in the camera settings.

You can disable that setting in the following section of DJI GO:

OMG, there is zebra hiding in your room

Thank you all for the help

Hi. Thank you for reaching DJI Forum. You may refer to the post #2 and #3 and please let us know if it helps.

You should read the manual for DJI Go. I learned quite a bit from it:
https://store.dji.com/guides/dji-go-4-manual/
There are some setting smentioned that might not apply to the Mavic Air as DJI Go is used for a lot of different models.

Oh, and you might want to be careful posting screenshots with your GPS location on them when you're at home ;)

Henrijs Posted at 2018-9-30 05:49
OMG, there is zebra hiding in your room

Those are over exposure lines, turn them off in camer settings