I tried my new RE goggles with my Mavic 2 Zoom tonight for the first time.

It is stuck on metric measurements, and I cannot find the way in settings to switch the display to imperial measurements, i.e., from meters to yards. The controller is setup imperial.

Any suggestions? I tried it with the Mavic 2 connected, then disconnected but still no luck.

Do I need to hook them up to my computer instead to change them?

I’ve already updated the firmware in everything.

Thanks!

Never mind folks, found it.

Never mind folks, found it.  When one goes into settings, mine was showing the very bottom items. There is a faint upward arrow above my choices, and once I selected it, there it was.  I DID reinstall the latest firmware version again right before that was visible so I am not certain whether or not that made it visible suddenly but nevertheless, that is where you change it. In Settings, you just keep scrolling up until another batch of selections appear.