I downloaded the new flight simulator

I have a Phantom 4 Pro V2, plugged into a USB port on my computer.  I can use DJI Assistant 2 software to validate that it 'sees' the controller

However the fight simulator doesn't seem to work with the controller.

Thoughts?

Hi. Thank you  for reaching DJI Forum. We do apologize for the troubles you had recently with the DJI Flight Simulator. You may refer to this for more information about installing your DJI Flight Simulator. Just remember some tips before installing the DJI Flight Simulator.

System requirements for the DJI Flight Simulator

Minimum System requirements: Processor: G4560; Graphics: GTX 1050 Ti; Memory: 16GB RAM; HDD: 80GB Free

Recommended System requirements: Processor: i5-6400; Graphics: GTX 1060 or GTX 1070; Memory: 16GB RAM; HDD: SSD+80GB Free

Optimal System requirements: Processor: i7-7700; Graphics: GTX 1080 Ti; Memory: 32GB RAM; HDD: SSD+80GB Free

My configuration :

• Intel I9-7900X CPU (10 cores, 20 threads)
• 64GB of memory
• GTX-1080 graphics board
• SSD drive with 1.3TB of free space
  

I don't have the P4P V2, but the connection to my P4 controller from the PC is via the micro USB port on RC. You may be using the full sized USB.

I am using the micro USB port.  

Try lowering the screen or window resolution to 1920 or lesss.   I had a simiilar issue when I was 1st playing around with it.  The screen would start for a fraction of a secion tand then stop.   IT worked fine after lowering the resolution

in the folder where you d intalled The Dji Sim , there are an archive related with Usb Drivers , it is an .exe , this file intall the drivers needed to run the Software.
execute it as admin.

File name is : dji_usb_5512_64_108