Paukert
lvl.1
Canada
Offline
|
Hello,
I hadn't used my Phantom 2 for half a year or more. I had long been meaning to change the vertical limitation and get some vids from higher than I have in the past. So I just got it out again and tried to connect it to the software and make that change.
First off, I was disappointed to see on the DJI website that it appears there may not even be much technical support for the Phantom 2 anymore. But, anyway, when I tried to connect the controller and make the vertical limit change, it will not connect. I am using DJI Phantom 2 Vision Assistant_3.8 and have tried to connect using two different Windows 10 laptops. The app loads up about 2/3 of the way, gets stuck, but offers me to 'skip,' so I click on that. The app appears to finish loading properly. I can navigate through the app's tabs ok. But when I try to make any changes I get a message that says to 'connect the controller,' even though it already is connected.
The controller still functions just fine to fly my Phantom 2. I just can't make any changes to the parameters.
Anything you can see here that I'm doing wrong?
Thanks,
Gary
|
|