I know this kind of post has foregone me a hundred times already athough each one is slightly different but wondered if anyone has any other suggestions or advise.
The attached video shows the gimbal-dance on startup & its the same weather its through the DJI Go-App or just on its own like this.
Firmware is the most recent.
When I use the DJI Go-App i can focus the camera, change F-stops etc, but just cant control the gimbal using the controllers left hand roller-switch.
Any ideas...
Excuse my wife's comments about the dishwasher although they might make you chuckle...!
any recent hard landing?
i would remove the x5 and check the PC board there on the top of gimbal mount that is clean, and not loose. also check the bird side gimbal mount that its clean and no pins are bent or misaligned
lvl.1
lvl.4
