txtechnonerd
lvl.4
Flight distance : 175075 ft
United States
Offline
|
Yeah. I actually printed one before this one that was just too tight. I had to scale this one up by around .75% to get a good fit. It could have used another .25 to .5% and it would have still been fine. Variations in materials, printers, conditions during print, etc. are always going to affect things. This one is printed with 1.75mm PLA+ from Monoprice. I printed at 1.5mm layer height, 40% infill w/full honeycomb pattern, extruder temp @ 190C and bed temp @ 60C. I added a glass bed to my MPMD mainly because I like that smooth first layer, but it also just makes things easier to deal with in general. I think my next try is going to be a phone support for the Osmo Pocket! |
|