fans88535ce0
lvl.2
Flight distance : 1417123 ft
Canada
Offline
|
DJI Gamora Posted at 1-9 10:12
Hi there, thank you for reaching out and we're very sorry to hear about the trouble. With regards to that make sure you update Both the Remote and Lightbridge for them to be compatible with each other.
Hi Dji Support,
I'ce done the updates on both Lightbridge 2 on the Air unit (m600 pro) and both controllers (master and slave) which cause me to loose connection on the slave controller.
The master controller is working fine alone and I can tilt the Ronin mx, but the slave unit is keep loosing its connection to the master unit and try to connect repeatedly. It connects momentarily and looses it right after.
I had no problem with previous firmware on the controller and Lightbridge firmware version 1.1.60.
I did also updated all Ronin MX, it's IMU, start stop unit and anything else was there to match up.
The DJI go App softwares both on master and slave controller are updated also.
Note: when slave controller tries to reconnect, the master controller also loses it's control over ronin mx gimbal. It seems like the slave reconnection sequence interrupts the whole gimbal controller, even on master controller.
Please check the screenshot |
|