We are up to date on all firmware is for inspire two and remote controls for dual op.  Both remotes had the same gremlins, pilot and cam op.  During our job yesterday when the camera operator would press the record button on the remote control instead of rolling, it would re-center the camera. The previous day there were no problems.  In addition the c1 button could not be used to re-center on all axis when chosen.  I’m not sure what to make of these gremlins. #AnotherDJIThing

DJI support????

Hi Aerography, sorry for the troubles with the RC, please try to reset RC to see if the issue persists: after powering on the RC, keep pressing C1+C2+Shutter button, then power off the RC and power on again, the settings of RC will be reset, then please set the Master and Slave RC.