Overview:

• Date: 2019.01.28
• Aircraft Firmware: v01.02.0300
• Remote Controller Firmware: v01.01.0060
• DJI GO 4 app: iOS v4.3.10 or above, Android v4.3.10 or above
  

What’s New?

• The Inspire 2 remote controller is now compatible with Multilink and can be used as a master or slave controller in the master-slave controller network.
  

Notes:

• Make sure the Multilink is not attached to the remote controller during the firmware update.
• If the firmware update fails, restart the remote controller and retry.
• If you do not intend to use Multilink, then you are not required to update the firmware for the Inspire 2.
  

Hello.I have upgraded to the new firmware 'Inspire 2 RC 01.01.0060' and now my x5s camera will tilt up or down, is this a known issue, is there a fix for this?

Hello.  I have upgraded to the new firmware 'Inspire 2 RC 01.01.0060' and now my x5s camera will NOT tilt up or down, is this a known issue, is there a fix for this?

Richard Dean Posted at 2-3 11:56
Hello.  I have upgraded to the new firmware 'Inspire 2 RC 01.01.0060' and now my x5s camera will NOT tilt up or down, is this a known issue, is there a fix for this?

Did you check the button settings?
Might have gotten overwritten in the update.

I performed the update via CrystalSky. The update stopped at 99%. The status-LED turns red for 2 seconds. A beep was heard and the RC switches off. I tried many ways to reactive the rc
https://forum.dji.com/thread-185884-1-1.html
all with the same result: the rc is connected as an p4pro RC and failed by normal switching it on. In safe mode its the same.

Any ideas?

Greetings from Hamburg,
Sven

LuftbildHamburg Posted at 4-6 07:50
I performed the update via CrystalSky. The update stopped at 99%. The status-LED turns red for 2 seconds. A beep was heard and the RC switches off. I tried many ways to reactive the rc
https://forum.dji.com/thread-185884-1-1.html
all with the same result: the rc is connected as an p4pro RC and failed by normal switching it on. In safe mode its the same.

Hello Luftbildhamburg,

Just downgrade your RC and then upgrade again and it should be alright. Had the same problem and it worked for me. Just ignore the info that you downgrade as a p4pro and do it anyway.

Good luck and give me some feedback