I am having gimbal overloaded problem in some flights, it’s show this message:
“Gimbal motor overloaded. Check if the gimbal clamp is mounted off”
After that, I land, then auto gimbal calibrate. After that it works well for some time, then again it goes overloaded during flight. When this occurs, gimbal looks untied.. not stabilized.
It’s strange because not happens all the times, each 10 flights it happens 1 time..
Suren Posted at 2-1 06:12
this looks like it is caused by the strong winds, do you get this same warnings in calmer weather
Usually no.. but wind isn’t that strong. It’s about 24km/h (15mph).. I already had gimbal glitch, but disarm is much danger. I need land to do auto calibration to fix it.. do you guys think that’s hardware or software problem? It’s normal disarm gimbal with higher wind?
Hello and good day Bi7ZlTnWOoJb. I am sorry to know that you are having issues with the gimbal of your DJI Mavic 2 Pro. May I please know whether the aircraft had a hard landing or crashed before this issue happened?