I had to reinstall Win10 (comp 1773) as well as DJI Assist 1.2.4 (Mavic Air).

I was careful before installing Assist. disable the driver signing requirement.

Now that I had to update the firmware of M.Air (560) the following happens with Assist 1.2.4:

1) Recognize the Mavic Air - OK

2) Recognizing the Remote Control - NO

3) Update firmware 500 to 560 (4 batteries) - OK

4) Update NFZ (4 batteries) - NO (shutdown Assist)

Anyone have any suggestions?

Might call / email DJI Support and ask them what's up...   There is always the delete and reinstall.   


Know anybody who has Windows, Assist 1.2.4, and MA that could give it a whirl?

HedgeTrimmer Posted at 2-28 06:21
Might call / email DJI Support and ask them what's up...   There is always the delete and reinstall.   

Partially solved.
I uninstalled version 1.2.4, installed version 1.07, then version 1.2.3 and then version 1.2.4.

Assist 1.2.4 now recognizes the Remote Control.
I have not solved the problem of updating NFZ yet.
Crappy program.

HedgeTrimmer Posted at 2-28 06:21
Might call / email DJI Support and ask them what's up...   There is always the delete and reinstall.   

Partially solved.
I uninstalled version 1.2.4, installed version 1.07, then version 1.2.3 and then version 1.2.4.

Assist 1.2.4 now recognizes the Remote Control.
I have not solved the problem of updating NFZ yet.
Crappy program.

The LOG of the previous error was this:

TZero Posted at 2-28 06:25
Partially solved.
I uninstalled version 1.2.4, installed version 1.07, then version 1.2.3 and then version 1.2.4.

NFZ strikes again!

On positive side, at least DJI's NFZ software didn't do a forced water landing as mentioned in another thread.  

HedgeTrimmer Posted at 2-28 06:41
NFZ strikes again!

On positive side, at least DJI's NFZ software didn't do a forced water landing as mentioned in another thread.

GREAT !

HedgeTrimmer Posted at 2-28 06:41
NFZ strikes again!

On positive side, at least DJI's NFZ software didn't do a forced water landing as mentioned in another thread.

Can you provide the link of the thread that forced a water landing because of NFZ? Crazy!

Doc Ozzy Posted at 2-28 07:25
Can you provide the link of the thread that forced a water landing because of NFZ? Crazy!

My Mavik is 10 feet underwater because of the latest firmware update

HedgeTrimmer Posted at 2-28 16:37
My Mavik is 10 feet underwater because of the latest firmware update

Thank you. This post also helps to answer a similar question I had about NFZs.

Flying into warning zones above restricted altitude