Hi!
I got a Inspire 1 V2 and a X3 camera.
When I start upp the Inspire the camra works fine får 1-2 min then the gimbal get overload.
Tur the drone off and on agen and it works for 1-2 min, pictur i fine and it records but gimbal is dead.

Hi, good day myggan1. We do apologize for the inconvenience that this has caused. May I ask if you are currently using an updated firmware? If not, we highly recommend updating your firmware to the latest version to avoid any errors and problems. In addition, you may try to perform a gimbal calibration to see if there would be some changes. Please keep us posted on the latest updates for us to further isolate the issue.  Thank you for your kind and understanding. Have a good one!

Hi!

Yes I got no firmware update to download. Version 1.11.01.50+
Gimbal calibration did not help, no problem calibrating gimbal.
Gimbal motor overload? is it the circuit board two one of the motors that is not working ass intended?