Followed every step in videos. I set master for pilot and slave for gimbal. However slave is not finding the master to connect.

Both are saying connected to multilink when plugged in.

Hi there, sorry for all the trouble that it caused. May I know if you're referring on the video tutorial below? If not, kindly follow the steps on how to properly install and use Multilink. Also, please provide a short video for further checking. You can upload it by using google-drive or Dropbox and provide the link here. Kindly let me know if the issue persists, thanks!

Same problem here. Followed instructional video exactly.

DJI Paladin Posted at 2019-5-10 14:32
Hi there, sorry for all the trouble that it caused. May I know if you're referring on the video tutorial below? If not, kindly follow the steps on how to properly install and use Multilink. Also, please provide a short video for further checking. You can upload it by using google-drive or Dropbox and provide the link here. Kindly let me know if the issue persists, thanks!

https://www.youtube.com/watch?v=6B15PRbtkXg

What do you suggest, other than the PAINFULLY and nearly insultingly obvious following of the tutorial's instructions, if the problem persists?