wm37
New
Flight distance : 80551 ft
United Kingdom
Offline
|
I just bought a Matrice 600 pro and fitted a zenmuse x5. I plugged the M600 into my laptop and updated lightbridge and M600 software via the DJI assist app. I turned the RC on, powed on the drone and attempted to use DJI GO via my android phone. The DJI Go app says "Remote Controller Signal Weak" eventhought the M600 and RC are sitting side by site, out doors, away from any interfernce. No informaion on the M600 is available in the settings window. In the settings window the RC settings indicated that the "Remote Controller Function" is set to "Master", Remote Controller Name is RC3753 and the Password is 2586 (these are factory set values/Values provided when I first powered on the RC and M600). The light on the RC is red, it appears that the RC is not linked to the M600.
To re-link the RC to the M600 I followed the re-link instructions 1) enter RC Settings on the DJI go app, 2) click "Linking RC", 3) "Confirm Frequency Settings?" - click "OK" RC started beeping flashing blue 3) pressed the "link" button on the M600 4) waited while the RC contined to beep as it timed out 5) The RC eventually timed out after 60 seconds and did not relink.
Suggestions??
Thanks All
|
|