Please select Into the mobile phone version | Continue to access the computer ver.
DJI Phantom 3 Advanced - Problem Remote Controller Calibration
741 0 2019-6-13
Uploading and Loding Picture ...(0/1)
o(^-^)o
NandoAirOne
lvl.1
Italy
Offline

It's my first post here on this forum ... and I'm an Italian beginner! I greet you all!

So ..., I have a new DJI Phantom 3 Advanced. I have already done all the updates (drone, radio control, etc.) but every time I turn on the radio control there is an alternating tone of alarm and a flashing LED. I go to DJI GO in "Aircraft Status" and then in "Overall Status" where there is an alarm triangle icon.
Entering inside it tells me that the "Remote Controller Calibration" is needed .. In fact there is some problem with the left stick .. Here:

64472749_636243943516398_7430271947243520_n.jpg

I, following the instructions, do the "calibrate", leaving the stick in the central position and in fact from 4% it goes to 0% and immediately afterwards the acoustic alarm of the radio remote control ends and its led becomes fixed.

The problem is that every time I turn the radio control off and on again I have to do all this procedure ...: Each time the 4% error reappears.

But is this normal? How do you fix this ...?

2019-6-13
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules