I've been online and on the phone with DJI support at least three times each.

I've watched every single video I could find on YouTube. I've tried every single trick turning on the remotes and have had no luck blinking. I've tried seven different devices. The results are all the same. The issue is I believe somehow the two remote controls have either an internal issue or have firmware update out of order or something is missing. The master remote blinks green and read when it's supposed to be linking to the aircraft. the slave remote stays solid purple and does not seem to be triggered or manipulated by any button combinations.

I'm supposed to do a job tomorrow with the inspire but it looks like I'm going to have to revert back to P4Ps

I've been online and on the phone with DJI support at least three times each.

I've watched every single video I could find on YouTube. I've tried every single trick turning on the remotes and have had no luck blinking. I've tried seven different devices. The results are all the same. The issue is I believe somehow the two remote controls have either an internal issue or have firmware update out of order or something is missing. The master remote blinks green and read when it's supposed to be linking to the aircraft. the slave remote stays solid purple and does not seem to be triggered or manipulated by any button combinations.

I'm supposed to do a job tomorrow with the inspire but it looks like I'm going to have to revert back to P4Ps