The Gel Blaster is super weak. The pellets have almost no velocity and just sort of fall out of the barrel of the blaster. Anyone have any ideas on how to resolve this one?

Did you let the Gel Beads soak long enough in water? DJI recommends that gel beads be soaked for four (4) hours before being used.

Send image gel beads....maybe more hours in water

Did you figure it out?

After searching the area, the members located two more automatic firearms. The weapons seized are the type that can be known as gel blaster, airsoft, hydro blaster or gel ball firearms. Under the Firearms Act NT, it is illegal to be in possession of these firearms.

What are you saying here?

Sorry to get back here. I cleaned out the barrel with compressed air and prepared fresh pellets with 1000ml of water. It works fine now.

Hello

This is a common issue, first, you should choose hardened gel balls.
Second, upgrade some parts to metal material
Third, upgrade some gears like motors, hop up to increase the fire rate and range
Use lubricant oil into the gearbox to let it run smoothly

Best wishes
ZHENDUO Gel Blaster

hey did you check my post above, help the explanation helps, I added you as a friend. zhenduo gel blaster has great professional knowledge on gel soft toy gun, contact us at any time!

Do you really need 1000mL of water for 500 beads (one cap full)?   1000mL is 1 liter or about 1 quart.   Seems 8oz of water is all you really need.

I have the problem that the blaster does not connect. The app shows a red warning. It worked before. Not sure what to do. Any suggestions?

Same issue here, Blaster worked and now a Red X in the app. Only two days old- any idea how to troubleshoot?

Update... Blaster status toggles on/off by slightly moving cable at the base of the Blaster.  This piece came assembled in the box... Bad part?

djiuser_DwErb8I7pxfa Posted at 1-13 17:44
Update... Blaster status toggles on/off by slightly moving cable at the base of the Blaster.  This piece came assembled in the box... Bad part?

Mine does still not connect, support says I should send the whole roboter, but it works in the DIY promming area. The infrared does not work. For me it seems this is a software problem. Which cable do you mean? May you make a screenshot? I also agree that the blaster was very weak, gel beads often roll out of it very slow, even with enough water.

zhenduo Posted at 2019-11-12 01:30
Hello

This is a common issue, first, you should choose hardened gel balls.

I had a similar issue. It solved by hardening the gel balls. Thanks.