HungaroDrone
lvl.1
Hungary
Offline
|
Hi everybody,
I have also run into the now known issue with the Zenmuse XT and XT2 cameras.
Unfortunately my XT2 does not show any live picture when attached to the Matrice 210 drone. I have control over the gimbal and can see a temperature data on the black screen, but unable to achieve a proper live picture. I also detected that the XT2 now requires two SD cards to be inserted in the two SD card slots, otherwise I receive an error message saying that the camera requires an SD card for either slot 1 or slot 2.
I have the latest firmware installed on the Matrice 210 and the XT2 (Zenmuse XT2 Firmware V01.00.00.20) as well.
However, I noticed that the XT2 now refuses to re-install the firmware as if no SD card would be inserted.
I also noticed that using dual downward payload, neither the XT2 nor my other camera, the Zenmuse Z30 shows any picture. However, if I attach only the Z30 to the drone, it presents a live picture.
According to the DJI Pilot app, the drone is ready for flight, the status of every component is normal.
Please advise how I can solve this issue.
Thanks!
Gábor
|
|