Was able to buy one from a store in Germany, official dji product with the retail packaging etc.  However when i install the plate the front of it hangs down quite  abit more than most of the vids i've seen.

In a few vids i noticed there was some talk about the plate pushing the 2 gimbal cables up into the slot above so was surprising to me to see it hanging a good inch or so below that point.  Have they made a new revision or am i missing something stupidly easy?   Everything is installed per the video guides ive seen so not sure whats going on here.

Another angle of it.

Nevermind, figured it out.  Had the front bracket attached to the top of the rubber mounts instead of the ones underneath.  

Gerv55 Posted at 8-27 17:16
Nevermind, figured it out.  Had the front bracket attached to the top of the rubber mounts instead of the ones underneath.

I was going to say that looked like a modified gimbal plate - they only made the one type as far as I am aware.