Have this unsolved issue since some days and can't find any good answers to the problem.
I have created a very complex Eaypoint Mission and evry time I try to let it go I get this message: "Invalid turning radius" But it does'nt tell whats wrong with the turning radius.
Please help me!

Try to update the firmware, waypoints have been improved.

Hi. did you end up solving the “invalid turning radius” error? I have the same issue.

Hi. did you end up solving the “invalid turning radius” error? I have the same issue.

vasylly@icloud.com Posted at 7-15 21:56
Hi. did you end up solving the “invalid turning radius” error? I have the same issue.

Hi! Dji Go4 did’nt solve the problem so I switched over to Litchi where it works perfecly!

pjotrett Posted at 7-16 00:42
Hi! Dji Go4 did’nt solve the problem so I switched over to Litchi where it works perfecly!

I solved it, the error may occur if you happen to move an arced waypoint, which may then make the previous arc radius invalid,  just go back into the moved waypoint and redo / recheck the arc by swiping up/down to ensure the arc ‘snaps’ back into an acceptable range