Hi There

Got a strange issue with my OA

About a week ago i upgraded to latest firmware via the MIMO app.  All seemed to work fine and i was able to use hyperlapse

Not long after I left the OA on charge and when I came back the next day, it seemed to have gone back to factory settings.   I had to setup time and date again

The firmware reports at being 6436 and I have no hyperlapse

When using MIMO, it doesn't prompt for upgrading firmware and I also put the latest firmware onto the SD card and it doesn't detect that either

So I'm stuck at 6436 with no hyperlapse.

I also tried a factory reset, and that didn't help either

Any ideas?

No Suggestions?   Moderators?   I’m not the only one that’s had an issue.  

A mi tambien me pasa lo mismo, no hay solución?, es porque todavia tengo garantia , por si tengo que pasar a Gopro

I am having the exact same issue. Seems like no solution.

Please email to DJI support team at https://www.dji.com/support?site=brandsite&from=nav. They have solved my issue.

V2 Fun Learning Posted at 11-24 19:15
Please email to DJI support team at https://www.dji.com/support?site=brandsite&from=nav. They have solved my issue.

Thanks. What did you have to do?

I had the exact same issue. I worked with support and they finally wanted me to send in the camera.  Needless to say, some time went by and I never got around to sending it in.  

But, just yesterday I updated to the newest firmware and Hyperlapse is now back on my camera and everything appears to be working fine.

im holding on this update