Please select Into the mobile phone version | Continue to access the computer ver.
Phantom 2 GoPro
142 3 10-26 22:04
Uploading and Loding Picture ...(0/1)
o(^-^)o
M.Aamir
lvl.1
Pakistan
Offline

Hi Dear,
My Old Phantom 2 Go Pro drone have issue with H3-3D gimbal. Gimbal is not working, 12 volts on 8 pin cable (interface board)is not normal, Only 0.2 volt is present at that point.
Some body help me.

Regards,



10-26 22:04
Use props
Anonymous
***** See below *****
10-27 00:07
Use props
KEJ
First Officer

United Kingdom
Offline

If you are happy taking things apart I would do so and check all of the connections.  
Have you recently dropped or had a hard landing ?

If you are not too competent then I would take your drone to a local RC model shop or club for advice/repair.

Anything you have access to externally I would recheck connections and ensure then are all clean & fully home/plugged in etc.

10-27 00:08
Use props
DJI Stephen
Super Moderator

Offline

Hello and good day M.Aamir. I am sorry for the trouble and thank you for reaching out. For us to be able to help you further with your DJI Phantom 2 and with regards to this matter. Kindly please send an email to support@dji.com for further assistance and for us to assist you further. Thank you for your support.
10-27 09:53
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules