Hello, I am looking for confirmation on how the calibration point is saved into the MG 1-P. After field planning, a calibration point can be set using a reference point or landmark. So, once the offset has been rectified, the Calibration point is now the home point. If the drone lands in a different position to the Home point/Calibration point, and the battery is changed, does the drone remember the initial Calibration point?
Sometimes it is difficult to find a landmark to use as a Calibration Point, and some times a potential Calibration point is not suitable as a take off point. Is it possible to set a Calibration point (for example in a gateway to a field to use for future flights) and then shift the drone to a landing zone in a different place?

Hello, I am looking for confirmation on how the calibration point is saved into the MG 1-P. After field planning, a calibration point can be set using a reference point or landmark. So, once the offset has been rectified, the Calibration point is now the home point. If the drone lands in a different position to the Home point/Calibration point, and the battery is changed, does the drone remember the initial Calibration point?
Sometimes it is difficult to find a landmark to use as a Calibration Point, and some times a potential Calibration point is not suitable as a take off point. Is it possible to set a Calibration point (for example in a gateway to a field to use for future flights) and then shift the drone to a landing zone in a different place?