This is just for your reference.

nice vid! great teardown!

interesting !
thanks you

Interesting stuff!

Cool! Thanks for sharing

Nicely done, thanks for sharing.

Great video, thanks a lot!

Hello and good day Nelsonlee. Thank you for sharing this interesting video with us. Great find and thank you for your support.

https://www.rcgeeks.co.uk/blog/d ... ardown-whats-inside

Nelson please,I added a bright 5mm white led in one front eye of the MM, and connected it to the power distribution board, where is says 3.6 and GND

- Is that 3.6V, or a bit less ? White led usually accept 3.4v max. In my case it is working now, but the led is VERY bright
- How much power could I take from the power distribution ? I intend to add a bright white led to the 2nd eye, a strobe on the top, away from the GPS, for a better safety toward other flying planes, and may be a buzzer as seagulls are attacking my MM and I need to scare them away.

Thank you

Prometheus Unbound

I baught a spare controller for the mini to test the antenna mod, plus don't wanna void my warranty over a stupid reason.

However this eBay brand new controller worked with my mini fine, so I took it apart fine, replaced the pigtails (leads) no problem.... Putting it back together.... The gimbal wheel on the top left fell out with two little loop plastic pieces I cannot figure out how to get back together.... I didn't realize that small pcb above it didn't need to be removed.... Any help would be amazing.

Thanks