I updated it and just turned on.
However in extremely low light condition, it shows horrible red noise flashing.

There's no way to upload video directly on this forum,,
so I had to make simple video clip to upload on Youtube then got back a link from that.
Is there any way to upload video files?

I'm using iPhone X 13.2.3 and no problem to update new firmware V01.10.00.20 with Mimo App.
I actually didn't know there is an issue with them.

Sorry for the inconvenience , tech support will guide you to fix this issue.

DJI-ytao Posted at 11-29 00:17
Sorry for the inconvenience , we are dealing with this bug.

That's good news!

Hi GD NOOBS, we apologize for the troubles, I have sent you PM, please check and have a try, thank you.

DJI Mindy Posted at 11-29 01:42
Hi GD NOOBS, we apologize for the troubles, I have sent you PM, please check and have a try, thank you.

Can this be published publicly?

milehighsoapbox Posted at 11-29 13:37
Can this be published publicly?

Hi there, may I know if you also encountered this issue? If so, I'll also send you the temporary solution. Sorry for the inconvenience caused.

DJI Mindy Posted at 11-29 18:59
Hi there, may I know if you also encountered this issue? If so, I'll also send you the temporary solution. Sorry for the inconvenience caused.

Hi, I also have the issue where I cannot connect the Pocket to my iPhone. I updated the firmware yesterday, is there a fix?

dishrag Posted at 11-29 19:10
Hi, I also have the issue where I cannot connect the Pocket to my iPhone. I updated the firmware yesterday, is there a fix?

Well, in my case I didn't have any issue with connecting to my phone. (iPhone X)
I just pulled down to V01.09.00.10.

But still, the noise is not gone.

Was white balance set to auto when it happen?

Tide Posted at 12-1 07:23
Was white balance set to auto when it happen?

That happens when the exposure stop is at -3.0.
Other than that, it doesn't have any issue, ◡̈