fansc6086bb4
 lvl.1
United States
Offline
|
fansc6086bb4 Posted at 2-5 17:47
I have a similar issue with my drone not connecting to the controller. My Mavic Pro was in my basement wet bar cabinets when my house burned down. I was able to extricate it from the ruins after a couple months, but it was exposed to lots of moisture over its time "outdoors" and I had to unstick the prop motors and gimbal with some WD40. I purchased a used controller/battery/charger from a local who lost their mavic in a lake. The problem is that my drone will NOT go into the bind mode; yes I have ensured that the drone is not in WiFi mode. My brother has the identical drone, when I push his link button the LED light instantly changes from green to red. On mine, not so much. I have tried every firmware version available with identical behavior. Also did multiple factory resets. I was able to control the drone via WiFi mode, but I have not used it much as I only used my drone previously with the remote control. I am hoping someone else has had the same issue so I know what I need to do to get flying again. I have searched google and the forum and see many similar issues but most seem to be with the RC not the aircraft. Thanks in advance!
I just attempted to get help from DJI support over the phone. After confirming my drone won't connect to the remote, they said my only option is to send the drone in for diagnostics and repairs. Someone has to have already figured this out, please help me! |
|