Hi,
I found this guy who teach how to solve a pan drift  issue (https://www.youtube.com/watch?v=hpP1vo3IKrc) when i was in the  app, in motor parameters, on the offset calibration of the joint angle, i  misunderstood the tutorial and could not calibrate correctly with the  joystick, and now i cannot repeat the calibration because it went crazy  and hits the camera and force the motors, there goes a video of my case:  https://www.youtube.com/watch?v=YyreIsG5hvo
i tried to ''restore gimbal setup'' but it didn`t work, is there any  other way to factory reset? or to motor kill the gimball in order to  reajust from the app without putting the camera in danger?
thank you really much ! hope it's possible.

Hi,
I found this guy who teach how to solve a pan drift  issue (https://www.youtube.com/watch?v=hpP1vo3IKrc) when i was in the  app, in motor parameters, on the offset calibration of the joint angle, i  misunderstood the tutorial and could not calibrate correctly with the  joystick, and now i cannot repeat the calibration because it went crazy  and hits the camera and force the motors, there goes a video of my case:  https://www.youtube.com/watch?v=YyreIsG5hvo
i tried to ''restore gimbal setup'' but it didn`t work, is there any  other way to factory reset? or to motor kill the gimball in order to  reajust from the app without putting the camera in danger?
thank you really much ! hope it's possible.