djiuser_WFxwb3PkZgsK
lvl.3
Flight distance : 1972316 ft
United States
Offline
|
EDIT: I no longer believe this issue was caused by the firmware. This was user error. I had neglected to consider that I also just started using a screen recording app during my flights (AZ Screen Recorder). I Powered AC and RC on at home to test video link quality WITHOUT screen recording, and video link now appears 100% normal. As soon as I begin a screen recording, the video link distortion / lag re-appears. My mistake! I will confirm everything is functioning normally in flight when I have daylight for a test flight, but I am pretty confident the issue was only occuring during screen recording with a separate app on my phone. Thanks again to everyone who responded and sorry for the user error on my part.
Last night I updated the firmware to the new release 1.0.4, as well as the Fly app.
On all my flights on the previous 1.0.3 firmware I found the live video feed to the controller to have very good clarity and very low latency. Only a few times did I notice any minor distortion or lag, and those only occured when the MM was at a long distance from the controller.
Today I took the MM out for a flight and as soon as I turned on both the controller and the mini, I noticed the video feed to the controller was both very distorted and very laggy. I checked the transmission page in the Fly app, and the signal was shown to be strong and stable, with no interference. The transmission graph looked about the same as it had when I had checked it at this same location on previous firmware. I restarted the mini, the controller, and my smartphone. When powering all back on the video link problem persisted so I powered everything down and drove to another location where I've also had no problems with previous flights on the previous firmware.
At the second location I got the same results, video feed is extremely distorted and very laggy. This is occuring at ANY distance from the controller, whether I am 1 foot away or 1000 feet away. Repeated at a third location a few miles away where I have flown previously and the video link problem persisted at any distance from the controller.
I spoke briefly with DJI support on the phone who requested I send an email about the issue, which I have sent.
Is anyone else experiencing a similar issue?
Is it possible to downgrade back to the previous firmware to check if this update was the cause of my issue?
Any suggestions are appreciated, have a good day.
|
|