I have had to resort to getting an external phone mount for the contriller on my MA as my phone will not fit in the controller with the case on. I would rather not have to remove the case incase i drop the phone whilst removing from the controller but also am not a fan of how an external holder would position the phone.

I have seen a mod to cut back the rubber mounts that wrap around your phone but again i would rather not mess with the original kit. Does anyone know if any 3rd party sells replacement rubbers where i could either trim these, or where they sell them with varying thickness?

Thanks in advance.

These should work and would be cheaper and easier than modifying the RC jaws

https://www.aliexpress.com/item/32964533690.html?spm=a2g0o.detail.1000013.5.39336c7ddiL5fs&gps-id=pcDetailBottomMoreThisSeller&scm=1007.13339.146401.0&scm_id=1007.13339.146401.0&scm-url=1007.13339.146401.0&pvid=619e8ff2-4283-4989-8512-4b7d9e380987

lannes Posted at 1-24 03:38
These should work and would be cheaper and easier than modifying the RC jaws

https://www.aliexpress.com/item/32964533690.html?spm=a2g0o.detail.1000013.5.39336c7ddiL5fs&gps-id=pcDetailBottomMoreThisSeller&scm=1007.13339.146401.0&scm_id=1007.13339.146401.0&scm-url=1007.13339.146401.0&pvid=619e8ff2-4283-4989-8512-4b7d9e380987

Thank you - had seen things like this but hadnt realised they worked for thicker phones as well as "taller". May give these a go as i like where the controller positions the phone, and these arent too chunky to chuck in your bag (the reason i was looking at modding was to keep the controllers portability)

Hi. Thank you for reaching out to DJI Forum. I hope that our valued DJI co pilots can provide you the best information for this inquiry. Thank you for your valued support.