luuh71
lvl.1
Flight distance : 359567 ft
Germany
Offline
|
Hi DJI,
my DJI Go 4 app requested to calibrate my visual sensors with DJI assistant twice, so I tried to. Downloaded the assistant 2 for a pc, connected the device and followed the guidance. I did 3 complete calibrating runs, but always when finalizing the calibration runs into an error. I tried alot, but during the calibrating movements of the drone infront of the screen, everything was always fine. Screensize is ok, the device gets recognized properly...I do not know what the problem is. There is maybe just one thing to mention: I am running this specific firmware from DJI that has the pano mode included for the P4A (https://forum.dji.com/forum.php?mod=viewthread&tid=128796&extra=page%3D1%26filter%3Dtypeid%26typeid%3D639%26typeid%3D639). Might that be the reason?
What can I do to maybe finally do and successfully finish a calibration?
Any help is really highly appreciated!
Than ks,
Regards,
Lutz
|
|