Hello, I am new to the forum. I have a problem with the

Phantom

3 SE: I tried to update the firmware of the drone, but around 70% appeared a message indicating that the update failed. The message said to turn off and turn on the drone. Since then, the radio control (GL358wD model) is locked with the flashing green LED.
Can someone help me?
Perhaps with a command radio reset procedure ...

Eopedroza WELCOME HOPE IT HELP !

Bienvenido seas ! Espero que le sirva de ayuda

Hello and good day Eopedroza. I ams orry for the trouble this has causes and thank you for reaching out. Can you please try to link the your DJI Phantom 3 SE to your remote controller and see if the issue will still persist? Please refere to the video posted by Nebuchadnezzar on post #2. Please keep us posted fro further assistance. Thank you.

Nebuchadnezzar Posted at 3-2 23:27
Eopedroza WELCOME HOPE IT HELP !

Bienvenido seas ! Espero que le sirva de ayuda

HOLA EL CONTROL ENCIENDE PERO NO HACE EL SONIDO CLASICO DE ENCENDIDO Y LAS LUCES PARPADEAN EN VERDE, YA INTENTE LO DEL VIDEO PERO NO CONECTA.

You solved? I have the same problem. Let me know

franzsarazzi Posted at 2-16 07:12
You solved? I have the same problem. Let me know

No se pudo resolver, compre un control nuevo y me quede con el que no sirve para refacciones

DJI Stephen Posted at 2020-3-3 08:18
Hello and good day Eopedroza. I ams orry for the trouble this has causes and thank you for reaching out. Can you please try to link the your DJI Phantom 3 SE to your remote controller and see if the issue will still persist? Please refere to the video posted by Nebuchadnezzar on post #2. Please keep us posted fro further assistance. Thank you.

El control prende pero no hace el sonido de necendido y se queda con muces verde parpadenando no se pued enlazar ya que no se ve el wifi en el celular