Hi there,

I'm trying to figure it out what happened with an A3 controller which after crashed after a couple of seconds after it take off. The copter is a 6 rotor with 605s 170 kv motors, esc - alpha 60 hv and tmotors 2211 propellers. We were testing payloads capacity and after a testing the vertical speed the copter just tipped over and crashed. The logs apparently says that 2 of motors were reached maximum trust for a couple of seconds which seems pretty strange for the above motors considering that the payload was less than half of what it can theoretically take. I'm open to any suggestion anyone might have. I'm attaching here the log of the crash perhaps someone can tell us what happened.

https://gofile.io/?c=AgP8pO

TIA,

Ciprian

We apologize for what happened, it is recommended email to support@dji.com for the analysis, the team will help to check, thank you.