infohiltservices.nl
lvl.1
Netherlands
Offline
|
Hi there,
Still trying to solve the issue with the camera/gimbal.
Before ordering a new gimbal set I wanted to do one last thing. I exchanged the gimbal flat cable, but sadly this did not change the behavior of the camera/gimbal setup. It still acts erratically. Auto calibration of the gimbal does not go passed 5% and an IMU calibration does not affect anything. A manual gimbal calibration calls a cancel after the nose is tilted down while turning 360 degrees.
Here a little video on the camera/gimbal movement:
http://www.hiltservices.nl/uploads/films/DJIMavicPro_camera_gimbal_movement.mp4
As I changed out the flat cable and the problem still persists. So is it correct to conclude that exchanging the gimbal unit will not solve the issue?
Are there any options, tests I can do?
Thanks in advance,
Jan. |
|