Hey Everyone,

I've tried doing a search, but nothing.

Am I just missing it, or is there no where to calibrate the goggle voltage OSD. My goggle voltage in my OSD is about 0.5V's too low.

Thanks!

I would expect the setting to be on the battery tab in Betaflight. I have never needed to change this, but I did have to change current here.

Same here, the goggles voltage is lower then the goggle battery voltage.

4S
Goggle         14,6V
BATT        15,16V
                0,56V

3S
Goggle        10,9V
BATT        11,39V
                0,49‬V

same, after the last update

Tom_A Posted at 4-1 23:12
I would expect the setting to be on the battery tab in Betaflight. I have never needed to change this, but I did have to change current here.

No that's for your actual quad Lipo only. I have that adjusted on all my rigs already. Very useful tab, but not for the goggles itself

Xviews Posted at 4-2 05:30
4S
Goggle         14,6V
BATT        15,16V

ok, I get the same thing. Just wanted to make sure it wasn't a one off instance. I guess we just patiently wait for the next firmware. Not a huge deal I guess.